S-61R Pelican/Release Notes

From
< S-61R Pelican
Revision as of 01:55, 14 September 2022 by Kelly (talk | contribs) (V1.1 Release Notes (2022.02.18))
(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)
Jump to: navigation, search

1 V1.2 Release Notes (2022.09.13)

  • Updated for compatibility with kimbi bucket.

2 V1.1 Release Notes (2022.02.18)

  • Fixed Engines fail to flame out when fuel is exhausted
  • Fixed Starting engines without the apu running fails to cause transmission wear
  • Adjusted engine oil temps. when operating single-engine
  • Heater now consumes fuel
  • Reduced the Frequency of patient health state changes
  • Allowed radar altitude autopilot hover
  • Fixed gps commands top/bottom/down/up
  • Knobs now switchable by clicking backing
  • Added gps route command
  • Added working radios
  • Added weather 2.0
  • Added icing
  • Added deicing mechanisms
  • Added ILS approaches
  • Added HSI/NAV instruments to HUD
  • Added retreating blade stall effects
  • Moved severed rescue hoist cable repair to the workbench
  • Added slip indicator to HUD
  • Reworked AFCS to improve stability when transitioning to autohover

3 V1.0 Release Notes (2020.08.21)

  • Fixed bug in marker Beacons
  • Fixed GPS chat command bugs
  • Added searchlight chat commands
  • Made qstart set transponder to Normal
  • Added patient health change messages
  • Ignoring collisions with seated avi to avoid messages with the new LL region crossing code.
  • Integrated ramps into onboard
  • Added backboard and headblocks for stokes
  • Added checklist HUD
  • Added missing command summary notecard.

4 V0.9.3 Release Notes (2020.07.26)

  • Removed unnecessary tint on tail rotor.
  • Added "wx" commands for controlling ceiling.
  • Fixed "start" command message.
  • Added sounds for engine/apu fires.
  • Added more failure rates.
  • Fixed activating cable shear in "cargo" version causes bad behavior.
  • Added burned textures for the engines and apu
  • Added burned out bulbs for warning lights
  • Added box of replacement bulbs on workbench.
  • Fixed "Repair all resets the air bottle used flag but does not refill bottle"
  • Updated Emergency Fuel Control Levers checklist page

5 V0.9.2 Release Notes (2020.07.10)

  • Fixed "engine dies when engine controller fails"
  • Added engine chip lights
  • Updated scripts for "cargo conversion kit" compatibility.
  • Added "extra" textures
  • Added cargo conversion kit
  • Added covers
  • Fixed "starter/igniter sounds don't work when there are any failures"
  • Fixed "wheels keep spinning if A/C goes non-physical while in ground motion"

6 V0.9.1 Release Notes (2020.07.03)

  • Improved Emergency Fuel Lever Handling
  • Fixed "Turning off fluid consumption sets APU accumulator level to 0 and prevents APU starting"
  • Fixed "Tail rotor strikes damage main rotor instead"
  • Fixed "Anchoring too close to a sim edge can cause the aircraft to be flung around if it crosses the sim edge while anchored" (will auto unanchor on crossing)
  • Improved handling on water with wind.
  • Checklist fixes (e.g., missing diagrams)
  • Improved HD water bullet detection for engine fire suppression
  • Fixed "workbench does not clear fire detect flag on engine replacement"

7 V0.9.0 Release Notes (2020.06.26)

  • Initial public beta release.