Private Helicopter PTS

1 General Information

The flight standards division of Shergood Aviation as developed this test book to assist students, instructors and examiners in the conduct of practical tests for private pilot helicopter in the Shergood system. Flight instructors should use the book to help prepare applicants for practical tests. Applicants should be familiar with the this book and refer to these standards during their training.

1.1 Prerequisites

Applicants for a Private Helicopter rating in the Shergood system must meet the following qualifications:

1. Must have logged at least 10 hours of total flight time in a Shergood helicopter
2. Must have logged at least 3 hours of dual flight time in a Shergood helicopter in the previous 60 days
3. Must have a recommendation from a helicopter flight instructor

1.2 Special Emphasis Areas

Examiners shall place special emphasis upon certain areas of aircraft operation critical to flight safety. These shall include:

1. Positive Aircraft Control
2. Procedures for positive exchange of controls
3. Collision avoidance
4. Runway incursion avoidance
5. Wire strike avoidance
6. Risk management
7. Checklist usage
8. Adherence to all aircraft limitations

1.3 Aircraft and Equipment

The private pilot applicant is required to provide an airworthy, certificated aircraft for use during this practical test. In addition the aircraft must meet the following requirements:

1. Have fully functioning dual controls.
2. Be capable of performing all areas of operation appropriate to the rating sought.
3. Have all realism settings enabled.

1.4 Practical Test Procedures

The practical test shall consist of a knowledge portion and a flight portion. Generally the the test will begin with the knowledge potion and proceed to the flight portion only if the knowledge elements were satisfactory. Applicants shall be evaluates in ALL tasks listed for each area of operation.

1.5 Satisfactory Performance

Satisfactory performance is based on the applicants ability to safely:

1. Perform each task in each area of operation within the approved standards.
2. Demonstrate mastery of the aircraft with the successful outcome of each task never seriously in doubt.
3. Demonstrate sound judgement and aeronautical decision making.
4. Demonstrate single-pilot competence if the aircraft is certified for single-pilot operations.

1.6 Unsatisfactory Performance

The tolerances for each task represent the performance expected in good flying. If, in the judgement of the examiner, the applicant does not meet the standards of performance of any task performed, the area of operation is failed, and thus the practical test is failed.

The applicant or examiner may discontinue the test at any time once an area of operation has been failed. With the consent of the applicant, the test may be continue with the other areas of operation. The applicant will receive credit for all passed areas of operation. However, during the retest and at the discretion of the examiner, any task may be re-evaluated including those previously passed.

1.7 Discontinuance

When a practical test is discontinued for reasons other than unsatisfactory performance (e.g., RL interruption, equipment failure, weather, illness), then the examiner and applicant shall agree on a future time/place at which to continue the practical test. The applicant will receive credit for any tasks passed before the test was discontinued.

2 Areas of Operation

2.1 PREFLIGHT PREPARATION

2.1.1 Task A - Certificates and Documents

Objective: To determine that the applicant can explain:

1. Private pilot certificate privileges, limitations and recent flight experience requirements.
2. Pilot logbook or flight records
3. Airworthiness and registration certificates
4. Operating limitations, placards and instrument markings
5. Weight and balance data for the aircraft

2.1.2 Task B - Weather

Objective: To determine that the applicant:

1. Exhibits knowledge of the elements related to weather information by analyzing weather reports and charts for approved sources.
2. Make a competent go/no-go decision based on available weather information.

2.1.3 Task C - Cross-Country Flight Planning

Objective: To determine that the applicant:

1. Exhibits knowledge of the elements related for cross-country flight planning by presenting and explaining a pre-planned VFR cross-country flight, as previously assigned by the examiner.
2. Selects easily identifiable route checkpoints.
3. Selects the most favorable altitudes considering weather conditions and equipment capabilities.
4. Computes headings, flight time and fuel requirements.
5. Selects appropriate navigation systems.
6. Identifies required communication frequencies along the route of flight.

2.1.4 Task D - Performance and Limitations

Objective: To determine that the applicant:

1. Exhibits knowledge of the elements related to performance and limitations by explaining the use of charts, tables and data to determine performance and the adverse effects of exceeding limitations.
2. Computes weight and balance. Determines the computed CG is within aircraft limitations during all phases of flight.
3. Describes the effects of atmospheric conditions on the helicopter's performance.
4. Understand the cause and effects of retreating blade stall.
5. Considers the circumstances when operating within the "avoid" areas of the height/velocity diagram.

2.1.5 Task E - Operation of Systems

Objective: To determine that the applicant exhibits knowledge of the elements related to the operation of the systems on the helicopter provided for the practical test by explaining at least three of the following systems:

1. Primary flight controls
2. Powerplant
3. Main rotor and anti-torque
4. Landing gear, brakes, steering, skids or floats as applicable
5. Fuel, oil and hydraulic
6. Electrical
7. Pitot-static, vacuum/pressure and associate flight instruments, if applicable
8. Anti-icing, including carburetor heat, if applicable
9. Avionics equipment

2.2 PREFLIGHT PROCEDURES

2.2.1 Task A - Preflight Inspection

Objective: To determine that the applicant:

1. Exhibits knowledge of the elements related to preflight inspection. This shall include which items must be inspected, the reason for checking each item, and how to detect possible defects.
2. Inspects the helicopter with reference to the appropriate checklist.
3. Verifies the helicopter is in condition for safe flight.

2.2.2 Task B - Engine Stating and Rotor Engagement

Objective: To determine that the applicant:

1. Exhibits knowledge of the elements related to correct engine starting procedures. This shall include the use of an external power source when appropriate.
2. Positions the helicopter properly considering structures, surface conditions, other aircraft, and the safety of nearby persons and property.
3. Utilizes the appropriate checklist for starting procedures.

Note: Applicants must perform a manual start without use of the "qstart" command. However, in the event this is a retest, or continuation after a discontinuance and a full start was previously demonstrated satisfactorily, "qstart" may be used at the discretion of the examiner.

2.2.3 Task C - Before Takeoff Check

Objective: To determine that the applicant:

1. Exhibits knowledge related to the elements of the preflight check. This shall include the reasons for checking each item and how to detect malfunctions.
2. Positions the helicopter properly considering environmental conditions.
3. Properly divides attention inside and outside the cockpit/
4. Ensures that all engine instruments are suitable for runup and takeoff.
5. Avoids runway incursions and ensures no conflict with traffic prior to takeoff.

2.3 AIRPORT OPERATIONS

2.3.1 Task A - Radio Communications

Objective: To determine that the applicant:

1. Exhibits knowledge of the elements related to radio communications
2. Selects appropriate frequencies
3. Transmits using recommended phraseology
4. Acknowledges radio communications and complies with ATC instructions when appropriate.

Note: If the aircraft used for the practical test is not equipped with radios, this task should be evaluated during the knowledge portion of the practical test.

2.3.2 Task B - Traffic Patterns

Objective: To determine that the applicant:

1. Exhibits knowledge of the elements related to traffic patterns. This shall include procedures at airports and heliports, prevention of runway incursions, and collision avoidance.
2. Complies with proper traffic pattern procedures.
3. Maintains proper spacing from other traffic or avoids the flow of fixed-wing aircraft.
4. Corrects for wind drift to maintain proper ground track.
5. Maintains orientation with runway/landing area in use.
6. Maintains traffic pattern altitude +/- 100 feet and the appropriate airspeed +/- 10 knots.

2.3.3 Task C - Airport Signs, Markings and Lighting

Objective: To determine that the applicant:

1. Exhibits knowledge of the elements related to airport/heliport runway and taxiway operations with emphasis on runway incursion avoidance.
2. Properly identifies airport/heliport runway and taxiway signs, markings and lighting.

2.4 HOVERING MANEUVERS

2.4.3 Task C - Surface Taxi

NOTE: This task applies only to helicopters equipped with wheel-type landing gear.

2.5 TAKEOFFS, LANDINGS, AND GO-AROUNDS

2.5.5 Task E - Rolling Takeoff

NOTE: This task applies only to helicopters equipped with wheel-type landing gear.