SECTION 13. APPENDICES
1 COMMAND SUMMARY
| Command
|
Description
|
| help
|
Get link to aircraft documentation.
|
| menu
|
Post the main menu
|
| cycen
|
Center the cyclic
|
| pedcen
|
Center the pedals
|
| cv/cv0/cv1/cv2/cv3
|
Change camera view: toggle/cockpit/behind/overhead/underside
|
| fc/fc0/fc1/fc2
|
Fine control: toggle/off/fine/very-fine
|
| dc
|
Close all doors
|
| rb/rb0/rb1
|
Toggle rotor brake/Rotor brake on/Rotor brake off
|
| mlt
|
Toggle "mouse look touch"
|
| qstart
|
Do a quick start (skip full start procedure)
|
| qstop or stop
|
Do a quick shutdown (skip full shutdown procedure)
|
| hud
|
Get copy of hud
|
| winchhud/hoisthud
|
Get copy of hoist hud
|
| checklist
|
Bring out or stow the checklist
|
| s switch-name
|
Toggle the switch named "switch-name"
|
| s1 switch-name
|
Turn on the switch named "switch-name"
|
| s0 switch-name
|
Turn off the switch named "switch-name"
|
| sn switch-name
|
Set rotary or three position switch to position n.
|
| com1 freq
|
Set the COM1 radio frequency to freq
|
| com2 freq
|
Set the COM2 radio frequency to freq
|
| hf freq
|
Set the HF radio frequency to freq
|
| ap cmd
|
Autopilot command
|
| x cmd
|
Transponder command
|
| nav cmd
|
Navigation/VOR command
|
| w cmd
|
Winch/Hoist command
|
| wx cmd
|
Weather command
|
1.1 Autopilot Commands
Regular ASE Commands:
| Command
|
Description
|
| ap eng |
Hold the current airspeed and heading.
|
| ap alt |
Hold the current altitude. The ENG channel must already be engaged for altitude hold to be engaged.
|
| ap dis |
Disconnect the ASE.
|
Extended ASE Commands (must be enabled in @Realism menu):
| Command
|
Description
|
| ap hdg n |
Turn to heading n.
|
| ap r n |
Turn right by n degrees.
|
| ap l n |
Turn left by n degrees.
|
| ap u n |
Move up n feet.
|
| ap d n |
Move down n feet.
|
| ap hvr |
Enter autohover mode.
|
| ap to |
Take off to a hover.
|
| ap land |
Autoland the aircraft.
|
1.2 Transponder Commands
| Command
|
Description
|
| x nnnn |
Set transponder code to nnnn
|
1.3 Navigation Commands
| Command
|
Description
|
| nav nav1 freq |
Set NAV1 radio to freq
|
| nav nav2 freq |
Set NAV2 radio to freq
|
| nav obs1 hdg |
Set CD1 heading to hdg. Use "to" or "from" to set heading to/from station.
|
| nav obs2 hdg |
Set CD2 heading to hdg. Use "to" or "from" to set heading to/from station.
|
1.4 Weather Commands
2 SWITCH SUMMARY
This section describes the various switches in the S-58 and their functions (used with s, s1 and s0 commands for normal switches s0, s1, s2, etc. for rotary switches). Push buttons (marked with [b]), and rotary knobs (marked with [r]) are also shown here. Switches that are for RP purposes only and do not have an effect on the helicopter are marked [RP] in the description. For switches that have guards, the guard is addressed by appending a "-g" to the switch name (marked with [-g] after the name in the table below).
2.1 Switches
| Name
|
Description
|
| inv |
Inverter Select
|
| oildil |
Oil Dillution
|
| bstpmp |
Boost Pump
|
| clutch |
Clutch Engagement
|
| fuelcutoff |
Fuel Cut-off
|
| elt [ts] |
ELT
|
| fan |
Cabin fan
|
| pitot |
Pitot heat
|
| read |
Passenger Reading Lights
|
| posbrt |
Position light brightness
|
| alarm[-g] |
Crew alarm
|
| beacon |
Beacon
|
| sticktrim |
Stick Trim
|
| cablecut[-g] |
Hoist cable cut (cockpit)
|
| radio |
Radio master
|
| elecbarr |
Electric barrier door
|
| brake |
Parking Brake
|
| taillock |
Tailwheel Lock
|
| floodlts [ts] |
Flood and hover lights
|
| hoist [ts] |
Hoist Mode
|
| heat [ts] |
Cabin Heat
|
| posmode [ts] |
Position light mode
|
| cabinlts [ts] |
Main cabin lights
|
| dcpwr [ts] |
DC Power
|
| ckptdome [ts] |
Cockpit dome light
|
| hook [ts] |
Cargo hook mode
|
| ldglts [ts] |
Landing Lights
|
| servo [ts] |
Servo Mode
|
| cabCableCut[-g] |
Hoist Cable Cut (cabin)
|
| l-com1 |
COM1 listen
|
| l-com2 |
COM2 listen
|
| l-nav1 |
NAV1 listen
|
| l-nav2 |
NAV2 listen
|
| l-hf |
HF listen
|
| l-uhf |
UHF listen
|
2.2 Knobs
| Name
|
Description
|
Positions
|
| emerlts |
Instrument Emergency Lights |
0:off, 1-3:levels, 4:high
|
| conalts |
Console A Panel Lights (copilot) |
0:off, 1-3:levels, 4:high
|
| nonfltlts |
Non-Flight Instrument Lights |
0:off, 1-3:levels, 4:high
|
| fltlts |
Flight Instrument Lights (pilot) |
0:off, 1-3:levels, 4:high
|
| mags |
Magnetos/Ignition |
0:OFF, 1:L, 2:R, 4:BOTH
|
| fuelsel |
Fuel Indicator Select |
0:TOT, 1:FWD, 2:CTR, 3:AFT
|
| xpdr |
Transponder Mode |
0:off, 1:sby: 2:on, 3:alt, 4:tst
|
| cgtrim |
CG Trim |
0:F3, 1:F2, 2:F1, 3:CTR, 4:A1, 5:A2, 6:A3
|
| yawtrim |
Yaw Trim |
0:L4, 1:L3, 2:L2, 3:L1, 4:CTR, 5:R1, 6:R2, 7:R3, 8:R4
|
| txsel |
Transmit Select |
0:COM1, 1:COM2, 2:HF, 3:UHF
|
| wipers |
Windshield Wipers |
0:Park, 1:Off, 2:Fast, 3:Med, 4:Slow
|
