S-61R Pelican/Release Notes

1 V1.1 Release Notes (TBD)

• Fixed Engines fail to flame out when fuel is exhausted
• Fixed Starting engines without the apu running fails to cause transmission wear
• Adjusted engine oil temps. when operating single-engine
• Heater now consumes fuel
• Reduced the Frequency of patient health state changes
• Allowed radar altitude autopilot hover
• Fixed gps commands top/bottom/down/up
• Knobs now switchable by clicking backing
• Added gps route command
• Added working radios
• Added weather 2.0
• Added icing
• Added deicing mechanisms
• Added ILS approaches
• Added HSI/NAV instruments to HUD
• Added retreating blade stall effects
• Moved severed rescue hoist cable repair to the workbench

2 V1.0 Release Notes (2020.08.21)

• Fixed bug in marker Beacons
• Fixed GPS chat command bugs
• Added searchlight chat commands
• Made qstart set transponder to Normal
• Added patient health change messages
• Ignoring collisions with seated avi to avoid messages with the new LL region crossing code.
• Integrated ramps into onboard
• Added backboard and headblocks for stokes
• Added checklist HUD
• Added missing command summary notecard.

3 V0.9.3 Release Notes (2020.07.26)

• Removed unnecessary tint on tail rotor.
• Added "wx" commands for controlling ceiling.
• Fixed "start" command message.
• Added sounds for engine/apu fires.
• Added more failure rates.
• Fixed activating cable shear in "cargo" version causes bad behavior.
• Added burned textures for the engines and apu
• Added burned out bulbs for warning lights
• Added box of replacement bulbs on workbench.
• Fixed "Repair all resets the air bottle used flag but does not refill bottle"
• Updated Emergency Fuel Control Levers checklist page

4 V0.9.2 Release Notes (2020.07.10)

• Fixed "engine dies when engine controller fails"
• Added engine chip lights
• Updated scripts for "cargo conversion kit" compatibility.
• Added "extra" textures
• Added cargo conversion kit
• Added covers
• Fixed "starter/igniter sounds don't work when there are any failures"
• Fixed "wheels keep spinning if A/C goes non-physical while in ground motion"

5 V0.9.1 Release Notes (2020.07.03)

• Improved Emergency Fuel Lever Handling
• Fixed "Turning off fluid consumption sets APU accumulator level to 0 and prevents APU starting"
• Fixed "Tail rotor strikes damage main rotor instead"
• Fixed "Anchoring too close to a sim edge can cause the aircraft to be flung around if it crosses the sim edge while anchored" (will auto unanchor on crossing)
• Improved handling on water with wind.
• Checklist fixes (e.g., missing diagrams)
• Improved HD water bullet detection for engine fire suppression
• Fixed "workbench does not clear fire detect flag on engine replacement"

6 V0.9.0 Release Notes (2020.06.26)

• Initial public beta release.