Difference between revisions of "H-34 Choctaw/Normal Procedures"

From
Jump to: navigation, search
(Prestart)
(Prestart)
Line 11: Line 11:
  
 
<ol>
 
<ol>
#Rotor Brake – ON
+
<li>Rotor Brake – ON
#Anti-collision lights – AS REQUIRED
+
<li>Anti-collision lights – AS REQUIRED
#Cabin lights – AS REQUIRED
+
<li>Cabin lights – AS REQUIRED
#All Light Rheostats - AS REQUIRED
+
<li>All Light Rheostats - AS REQUIRED
#Cabin Heater Switch - OFF
+
<li>Cabin Heater Switch - OFF
#Fan Switch - OFF
+
<li>Fan Switch - OFF
#Pitot Heater Switch - OFF
+
<li>Pitot Heater Switch - OFF
#Windshield Wiper Rotary Switch - OFF
+
<li>Windshield Wiper Rotary Switch - OFF
#Crew Alarm Bell - TEST
+
<li>Crew Alarm Bell - TEST
#Hoist Master Switch - OFF
+
<li>Hoist Master Switch - OFF
#Radio Master Switch - RADIO MASTER
+
<li>Radio Master Switch - RADIO MASTER
#Circuit Breakers - IN
+
<li>Circuit Breakers - IN
#Stick Trim Switch – ON
+
<li>Stick Trim Switch – ON
#Fuel Shutoff Valve - Open
+
<li>Fuel Shutoff Valve - Open
#Mixture Control Lever - IDLE CUT-OFF
+
<li>Mixture Control Lever - IDLE CUT-OFF
#Carburetor Air Lever - DIRECT
+
<li>Carburetor Air Lever - DIRECT
#Clutch Pump Switch - OFF
+
<li>Clutch Pump Switch - OFF
#Servo Switch – ON
+
<li>Servo Switch – ON
#Parking Brake Handle - RESET
+
<li>Parking Brake Handle - RESET
#Tail Wheel - LOCKED
+
<li>Tail Wheel - LOCKED
#Radios, Radar Altimeter, IFF - OFF
+
<li>Radios, Radar Altimeter, IFF - OFF
#Ignition Switch - OFF
+
<li>Ignition Switch - OFF
#Fuel Booster Pump Switch - OFF
+
<li>Fuel Booster Pump Switch - OFF
#External Power - ON (voltage checked)
+
<li>External Power - ON (voltage checked)
#Battery-Generator Switch - BATT ONLY (voltage checked) Note: When starting without external power, the battery-generator switch must be in the BATT ONLY position to energize the starter relay and engine primer which are connected to the secondary bus.
+
<li>Battery-Generator Switch - BATT ONLY (voltage checked) Note: When starting without external power, the battery-generator switch must be in the BATT ONLY position to energize the starter relay and engine primer which are connected to the secondary bus.
#Fuel Pressure – Check
+
Fuel Pressure – Check
 
<ol style="list-style-type:lower-alpha">
 
<ol style="list-style-type:lower-alpha">
 
<li>Fuel Shut-Off Switch - CLOSED</li>
 
<li>Fuel Shut-Off Switch - CLOSED</li>
Line 44: Line 44:
 
<li>Fuel Booster Switch- FUEL BSTR PUMP</li>
 
<li>Fuel Booster Switch- FUEL BSTR PUMP</li>
 
</ol>
 
</ol>
#Clutch Pump Warning Light - TEST
+
<li>Clutch Pump Warning Light - TEST
#Instr. Pwr. Failure Warning Lights - TEST
+
<li>Instr. Pwr. Failure Warning Lights - TEST
#Fuel Low Level Warning Light - TEST
+
<li>Fuel Low Level Warning Light - TEST
#Rotor Brake Warning Light - TEST
+
<li>Rotor Brake Warning Light - TEST
#Generator Warning Light - TEST
+
<li>Generator Warning Light - TEST
#Collective - DOWN
+
<li>Collective - DOWN
#Throttle – CLOSED
+
<li>Throttle – CLOSED
 
</ol>
 
</ol>

Revision as of 12:31, 7 July 2021

SECTION 6. NORMAL PROCEDURES

1 General

This section describes the procedures necessary to safely and efficiently operate your aircraft. A basic understanding of helicopter flight techniques is assumed.

2 Preflight Procedures

3 Normal Start-Up

3.1 Prestart

  1. Rotor Brake – ON
  2. Anti-collision lights – AS REQUIRED
  3. Cabin lights – AS REQUIRED
  4. All Light Rheostats - AS REQUIRED
  5. Cabin Heater Switch - OFF
  6. Fan Switch - OFF
  7. Pitot Heater Switch - OFF
  8. Windshield Wiper Rotary Switch - OFF
  9. Crew Alarm Bell - TEST
  10. Hoist Master Switch - OFF
  11. Radio Master Switch - RADIO MASTER
  12. Circuit Breakers - IN
  13. Stick Trim Switch – ON
  14. Fuel Shutoff Valve - Open
  15. Mixture Control Lever - IDLE CUT-OFF
  16. Carburetor Air Lever - DIRECT
  17. Clutch Pump Switch - OFF
  18. Servo Switch – ON
  19. Parking Brake Handle - RESET
  20. Tail Wheel - LOCKED
  21. Radios, Radar Altimeter, IFF - OFF
  22. Ignition Switch - OFF
  23. Fuel Booster Pump Switch - OFF
  24. External Power - ON (voltage checked)
  25. Battery-Generator Switch - BATT ONLY (voltage checked) Note: When starting without external power, the battery-generator switch must be in the BATT ONLY position to energize the starter relay and engine primer which are connected to the secondary bus. Fuel Pressure – Check
    1. Fuel Shut-Off Switch - CLOSED
    2. Fuel Pressure Gage - ZERO PSI
    3. Fuel Shut-Off Switch - OPEN
    4. Fuel Pressure Gage - Check for Fuel Pressure Increase
    5. Fuel Booster Switch- FUEL BSTR PUMP
  26. Clutch Pump Warning Light - TEST
  27. Instr. Pwr. Failure Warning Lights - TEST
  28. Fuel Low Level Warning Light - TEST
  29. Rotor Brake Warning Light - TEST
  30. Generator Warning Light - TEST
  31. Collective - DOWN
  32. Throttle – CLOSED