H-34 Choctaw/Normal Procedures

SECTION 6. NORMAL PROCEDURES

1 General

This section describes the procedures necessary to safely and efficiently operate your aircraft. A basic understanding of helicopter flight techniques is assumed.

3 Normal Start-Up

3.1 Prestart

1. Rotor Brake – ON
2. Anti-collision lights – AS REQUIRED
3. Cabin lights – AS REQUIRED
4. All Light Rheostats - AS REQUIRED
5. Cabin Heater Switch - OFF
6. Fan Switch - OFF
7. Pitot Heater Switch - OFF
8. Windshield Wiper Rotary Switch - OFF
9. Crew Alarm Bell - TEST
10. Hoist Master Switch - OFF
11. Radio Master Switch - RADIO MASTER
12. Circuit Breakers - IN
13. Stick Trim Switch – ON
14. Fuel Shutoff Valve - Open
15. Mixture Control Lever - IDLE CUT-OFF
16. Carburetor Air Lever - DIRECT
17. Clutch Pump Switch - OFF
18. Servo Switch – ON
19. Parking Brake Handle - RESET
20. Tail Wheel - LOCKED
21. Radios, Radar Altimeter, IFF - OFF
22. Ignition Switch - OFF
23. Fuel Booster Pump Switch - OFF
24. External Power - ON (voltage checked)
25. Battery-Generator Switch - BATT ONLY (voltage checked) Note: When starting without external power, the battery-generator switch must be in the BATT ONLY position to energize the starter relay and engine primer which are connected to the secondary bus.
26. Fuel Pressure – Check
1. Fuel Shut-Off Switch - CLOSED
2. Fuel Pressure Gage - ZERO PSI
3. Fuel Shut-Off Switch - OPEN
4. Fuel Pressure Gage - Check for Fuel Pressure Increase
5. Fuel Booster Switch- FUEL BSTR PUMP
1. Clutch Pump Warning Light - TEST
2. Instr. Pwr. Failure Warning Lights - TEST
3. Fuel Low Level Warning Light - TEST
4. Rotor Brake Warning Light - TEST
5. Generator Warning Light - TEST
6. Collective - DOWN
7. Throttle – CLOSED