Difference between revisions of "S-61R Pelican/Release Notes"
(→V1.1 Release Notes (TBD)) |
(→V1.1 Release Notes (TBD)) |
||
| Line 2: | Line 2: | ||
* Fixed Engines fail to flame out when fuel is exhausted | * Fixed Engines fail to flame out when fuel is exhausted | ||
* Fixed Starting engines without the apu running fails to cause transmission wear | * Fixed Starting engines without the apu running fails to cause transmission wear | ||
| + | * Adjusted engine oil temps. when operating single-engine | ||
| + | * Heater now consumes fuel | ||
* Reduced the Frequency of patient health state changes | * Reduced the Frequency of patient health state changes | ||
| + | * Allowed radar altitude autopilot hover | ||
* Fixed gps commands top/bottom/down/up | * Fixed gps commands top/bottom/down/up | ||
* Added gps route command | * Added gps route command | ||
* Added working radios | * Added working radios | ||
* Added weather 2.0 | * Added weather 2.0 | ||
| + | * Added icing | ||
| + | * Added deicing mechanisms | ||
| + | * Added ILS approaches | ||
| + | * Added HSI/NAV instruments to HUD | ||
| + | * Added retreating blade stall effects | ||
== V1.0 Release Notes (2020.08.21) == | == V1.0 Release Notes (2020.08.21) == | ||
Revision as of 17:40, 30 December 2021
Contents
1 V1.1 Release Notes (TBD)
- Fixed Engines fail to flame out when fuel is exhausted
- Fixed Starting engines without the apu running fails to cause transmission wear
- Adjusted engine oil temps. when operating single-engine
- Heater now consumes fuel
- Reduced the Frequency of patient health state changes
- Allowed radar altitude autopilot hover
- Fixed gps commands top/bottom/down/up
- Added gps route command
- Added working radios
- Added weather 2.0
- Added icing
- Added deicing mechanisms
- Added ILS approaches
- Added HSI/NAV instruments to HUD
- Added retreating blade stall effects
2 V1.0 Release Notes (2020.08.21)
- Fixed bug in marker Beacons
- Fixed GPS chat command bugs
- Added searchlight chat commands
- Made qstart set transponder to Normal
- Added patient health change messages
- Ignoring collisions with seated avi to avoid messages with the new LL region crossing code.
- Integrated ramps into onboard
- Added backboard and headblocks for stokes
- Added checklist HUD
- Added missing command summary notecard.
3 V0.9.3 Release Notes (2020.07.26)
- Removed unnecessary tint on tail rotor.
- Added "wx" commands for controlling ceiling.
- Fixed "start" command message.
- Added sounds for engine/apu fires.
- Added more failure rates.
- Fixed activating cable shear in "cargo" version causes bad behavior.
- Added burned textures for the engines and apu
- Added burned out bulbs for warning lights
- Added box of replacement bulbs on workbench.
- Fixed "Repair all resets the air bottle used flag but does not refill bottle"
- Updated Emergency Fuel Control Levers checklist page
4 V0.9.2 Release Notes (2020.07.10)
- Fixed "engine dies when engine controller fails"
- Added engine chip lights
- Updated scripts for "cargo conversion kit" compatibility.
- Added "extra" textures
- Added cargo conversion kit
- Added covers
- Fixed "starter/igniter sounds don't work when there are any failures"
- Fixed "wheels keep spinning if A/C goes non-physical while in ground motion"
5 V0.9.1 Release Notes (2020.07.03)
- Improved Emergency Fuel Lever Handling
- Fixed "Turning off fluid consumption sets APU accumulator level to 0 and prevents APU starting"
- Fixed "Tail rotor strikes damage main rotor instead"
- Fixed "Anchoring too close to a sim edge can cause the aircraft to be flung around if it crosses the sim edge while anchored" (will auto unanchor on crossing)
- Improved handling on water with wind.
- Checklist fixes (e.g., missing diagrams)
- Improved HD water bullet detection for engine fire suppression
- Fixed "workbench does not clear fire detect flag on engine replacement"
6 V0.9.0 Release Notes (2020.06.26)
- Initial public beta release.
