Difference between revisions of "H-34 Choctaw/Limits"
(→Rotor Limits) |
(→Engine Operating Limitations) |
||
Line 36: | Line 36: | ||
==== Engine Operating Limitations ==== | ==== Engine Operating Limitations ==== | ||
− | Engine overspeeds up to 2900 RPM are allowable. Engine overspeeds from 2900 to 3000 RPM require an inspection of the engine and fan assembly. Overspeeds | + | Engine overspeeds up to 2900 RPM are allowable. Engine overspeeds from 2900 to 3000 RPM require an inspection of the engine and fan assembly. Overspeeds beyond 3000 rpm require removal and overhaul of the engine. |
=== Loading Limits === | === Loading Limits === |
Revision as of 12:16, 7 July 2021
SECTION 4. LIMITS
Contents
1 General
1.1 Purpose
This chapter identifies the operating limitations that should be observed by the flight crew during operation of this helicopter.
1.2 Minimum Crew
The minimum crew required to operate this helicopter is one pilot and one copilot.
2 System Limits
2.1 Instrument Markings
All instrument markings should be observed while flying this helicopter.
- Lower Red Radial - The red radial having the lowest numerical value on an instrument indicates that a dangerous condition would exist if the pointer should drop to or below that value during flight.
- Yellow Arc or Radial - A yellow arc or radial indicates that danger may exist under certain specified conditions. Operation in these regions may only be carried out in accordance with the limitations prescribed in this manual.
- Green Arc - A green arc indicates the region for continuous inflight operation.
- Upper Red Radial - The red radial having the highest numerical value on an instrument indicates that a dangerous condition would exist if the pointer should reach this value and that operation above this point is prohibited.
2.2 Rotor Limits
The following limitations apply to apparent rotor RPM (the RPM shown on the outer scale):
- Minimum RPM in autorotation: 1920 RPM
- Maximum RPM: 2915 RPM
The following inspections must be performed in the event of rotor overspeeds:
- 2915 to 3050 RPM - A visual inspection of the blades, hubs and control linkage, and tail rotor assembly should be performed.
- 3050 to 3500 RPM - A major overhaul of the main rotor hub should be performed. A visual inspection of all other components should be performed.
- Above 3500 RPM - The main rotors, tail rotors, and main rotor hub should be removed and scrapped and new components installed.
2.3 Engine Operating Limitations
Engine overspeeds up to 2900 RPM are allowable. Engine overspeeds from 2900 to 3000 RPM require an inspection of the engine and fan assembly. Overspeeds beyond 3000 rpm require removal and overhaul of the engine.
3 Loading Limits
3.1 Center-of-Gravity Limitations
See Fig. 6-1 for center-of-gravity limitations with respect to gross weight.
3.2 Maximum Gross Weight
The maximum gross weight is 22,050 pounds.
3.3 Cargo Hook Limitations
Maximum weight for external cargo is 8,000 pounds.
4 AIRSPEED LIMITATIONS
The maximum recommended indicated airspeeds are as follows:
- Forward flight: 150 knots
- Sideward flight: 35 knots
- Rearward flight: 20 knots
5 MANEUVERING LIMITS
The following maneuvers are not permitted:
- Acrobatics.
- Angles of bank exceeding 45 degrees.
- Hovering turns exceeding a rate of 360 degrees in 15 seconds.