Kelly: /* =Shutdown */

2021-10-23T04:21:29Z

‎=Shutdown

Kelly: /* Exterior Checks (Right Side) */

2021-10-23T04:21:11Z

‎Exterior Checks (Right Side)

Kelly: Created page with "SECTION 3. NORMAL PROCEDURES ===General=== This section describes the procedures necessary to safely and efficiently operate your aircraft. A ba..."

2021-10-23T04:15:56Z

Created page with "<span class=sa-section>SECTION 3. NORMAL PROCEDURES</span> ===General=== This section describes the procedures necessary to safely and efficiently operate your aircraft. A ba..."

New page

<span class=sa-section>SECTION 3. NORMAL PROCEDURES</span>

===General===
This section describes the procedures necessary to safely and efficiently operate your aircraft. A basic understanding of helicopter flight techniques is assumed.

===Preflight Procedures===
====Exterior Checks (Left Side)====
#Remove covers and chocks
#Main Rotors – check condition
#Left Transmission Compartment
##Generator #1 – check condition
##Hydraulic Pump #1 – check condition
##Hydraulic #1 Fluid Level – check level
#Left Engine Compartment
##Engine #1 – check condition
##Engine #1 oil level – check level
##Landing Gear - check
#Tail
##Tail Rotor – check condition
##T/R Transmission– check condition
##T/R Transmission Fluid – check level

====Exterior Checks (Right Side)====
Right Engine Compartment
Engine #2 – check condition
Engine #2 oil level – check level
Left Transmission Compartment
Generator #2 – check condition
Hydraulic Pump #2 – check condition
Hydraulic #2 Fluid Level – check level
Main Transmission – check condition
Main Transmission Fluid – check level
Interior Checks
Circuit Breaker Panel – check
Rotor Brake – check disengaged
Gear Lever – check down
BATT 1 – ON
Aircraft Event Log Check
MFD3 – FMD
Check log for unresolved faults
MFD3 - NORM
Exterior light check
NAV, Beacon and Ldg Lights – ON
Check correct operation of each light
NAV, Beacon and Ldg Lights – OFF
Periodic Checks (Perform every 5 hours)
Avionics Analyzer – place near Aircraft
WiFi Connection – verify established
Each Avionics System – verify functional
Avionics Analyzer – stow
Flight Procedures
Start Procedures
Cyclic & Pedals - CENTERED
Collective - FULL DOWN
Rotor Brake - OFF
Park Brake - PARK
Electrical Cutoff Bar - CLOSED
BATT1 & BATT2 - ON
Verify DC warning lights OFF
Verify ≥ 23V each bus
Use external power if < 23V
GEN1 & GEN2 - ON
ELT - CHECK ARMED
Anti-Collision - BOTH
Fuel Quantity - CHECK
Collective - LIFT SLIGHTLY
Verify low RPM warn sound
Collective - FULL DOWN
Test - ON
Verify overhead warning lights illuminated and fire warning alarm active.
Test - OFF
Verify warning lights out except FCR
FADEC 1 & 2 - ON & GUARDED
Engine #1 Control - IDLE
Wait for #1 N1 to reach 75%
Engine #2 Control - IDLE
Wait for #2 N2 to reach 75%
RA1 & RA2 - ON
FMS1 & FMS2 - ON
AHRS Select - AHRS1
DG CORR - DEPRESS
Verify DG and compass deviate & ALIGN warning lit
DG/MG - DEPRESS
Verify DG aligned, ALIGN out
AHRS Select - AHRS2
DG CORR - DEPRESS
Verify DG and compass deviate & ALIGN warning lit
DG/MG - DEPRESS
Verify DG aligned, ALIGN out
EMERG GEN - ON
Verify indicator on MFD
EMERG GEN - OFF
FMS/GPS Course - AS REQUIRED
Engine Control Guards - CLOSE
Engine #1 & #2 - FLY
Wait Eng 1&2 @ 100% N2
AFCS #1 & #2 - ON
All CAD Warnings - VERIFY OUT
Take-Off
N2 & NR - VERIFY 100%
NAV - AS REQUIRED
Transponder - AS REQUIRED
Fuel Quantity - CHECK
Doors - CHECK
CAD - VERIFY NO MSGS
Floats - AS REQUIRED
ARM for overwater flights
Crew & Passengers - BRIEF
Nose Wheel - FREE
Park Brake - FREE

After takeoff:
Climb - ESTABLISH
Landing Gear - UP
Verify three amber lights
Pre-Landing
Landing Gear - DOWN
Verify three green lights
Nose Wheel - FREE
Park Brake - FREE
Landing Lights - AS REQUIRED
Crew & Passengers - BRIEF

After Touchdown:

Floats - OFF
Cyclic - CENTER
Collective - FULL DOWN
Shutdown
Park Brake - PARK
Nose Wheel - LOCK
AFCS #1 & #2 - OFF
Engine Control #1 & #2 - IDLE
RA1 & RA2 - OFF
FMS1 & FMS2 - OFF
MFD3 - FMD
Check log for abnormal indications
MFD3 - NORM
Engine Guards #1 & #2 - OPEN
Engine Control #1 & #2 - OFF
Engine Instruments - MONITOR
GEN1 & GEN2 - OFF

When rotor RPM < 50%

Rotor Brake - ON

When rotor has stopped:

All Lights - OFF
BATT1 & BATT2 - OFF
Verify ELT - NO LIGHT

@@ Line 135: / Line 135: @@
 #Collective - FULL DOWN
-====Shutdown===
+====Shutdown====
 #Park Brake - PARK

H-160/Normal Procedures - Revision history

Kelly: /* =Shutdown */

Kelly: /* Exterior Checks (Right Side) */

Kelly: Created page with "SECTION 3. NORMAL PROCEDURES ===General=== This section describes the procedures necessary to safely and efficiently operate your aircraft. A ba..."